compiling speakfreely 7.2

compiling speakfreely 7.2

[Cheryl Homiak]

I think I can answer the question from yesterday about the "commands commence
before target" or something similar, because the same thing happened to me.
It probably means you uncommented the wrong line. In my case, I commented an
earlier line with duplex in it instead of waiting till I got to the one that
starts "duplex =" without the quotes of course.
Hope this helps.

Re: compiling speakfreely 7.2

[Igor Gueths]

Hi Cheryl. Thanks for the info on that one, will try it today at some
point. Just out of curiosity, when make refered to the target in my error
message from yesterday, is target refering to the duplex of your audio
hardware? Because when I saw target, I immediately thought system
architecture i.e., i686. I searched for that, but found nothing related.
Then I got confused.

On Thu, 18 Apr 2002, Cheryl Homiak wrote:

> I think I can answer the question from yesterday about the "commands commence
> before target" or something similar, because the same thing happened to me.
> It probably means you uncommented the wrong line. In my case, I commented an
> earlier line with duplex in it instead of waiting till I got to the one that
> starts "duplex =" without the quotes of course.
> Hope this helps.
>
>
> _______________________________________________
> Speakup mailing list
> Speakup@braille.uwo.ca
> http://speech.braille.uwo.ca/mailman/listinfo/speakup
>

Re: compiling speakfreely 7.2

[Cheryl Homiak]

Hi Igor and all.

I'm really not sure, except that you were trying to carry out a command before
the setup parameters or something else important was defined.
Hope that turns out to be the answer to your problem

Re: compiling speakfreely 7.2

[Igor Gueths]

Hi. In this case, it is a bit difficult I think to determine the exact
source to the problem. If I knew what it was refering to by a target, then
I could probably determine the problem and fix it.

On Thu, 18 Apr 2002, Cheryl Homiak wrote:

> Hi Igor and all.
>
> I'm really not sure, except that you were trying to carry out a command before
> the setup parameters or something else important was defined.
> Hope that turns out to be the answer to your problem
>
>
>
> _______________________________________________
> Speakup mailing list
> Speakup@braille.uwo.ca
> http://speech.braille.uwo.ca/mailman/listinfo/speakup
>