dosemu: com ports

dosemu: com ports

[Cheryl Homiak]

Does anybody have an installation using dosemu on which access to your com ports
is actually working. If so, I would like to hear how you set this up.
In linux
and in DOS, I can copy to the versabraille on my second com port (/dev/ttyS1 and
com2 respectively). However, in dosemu, it is announced that one file has been
copied but the port is apparently never actually accessed.
TIA.

Re: dosemu: com ports

[Ari Moisio]

Hi!
Cheryl Homiak 20.03.02:

>Does anybody have an installation using dosemu on which access to your com ports
>is actually working. If so, I would like to hear how you set this up.
>In linux

  I have following lines in dosemu.conf - i thin they are defaults
$_com1 = "/dev/cua0"    # e.g. "/dev/mouse" or "/dev/cua0"
$_com2 = "/dev/cua1"    # e.g. "/dev/modem" or "/dev/cua1"

  In addition i have also commented out everything about mouse.

  At least my serial synth works quite ok - it sometimes drops long
sentences.

  Are you sure all connection speeds are set correctly, does it help if
you set speed with setserial or stty?


-- 
Mr. Ari Moisio, Niittykatu 7, 41160 Tikkakoski, +358-40-5055239
ari.moisio@iki.fi http://www.iki.fi/arimo PGP-keyID: 0x3FAF0F05

Re: dosemu: com ports

[Cheryl Homiak]

Hi!
Haven't tried using setserial or stty but can do this; I think the settings in
linux are ok because I can use my serial ports fine in linux.
I am using /dev/ttySx instead of /dev/cuax. Should there be any need to use the
older cua and if so how do ai go about doing this since I don't even have these
in my /dev?
Thanks.